Yipeeee!!! Installing as I type. So I finally found out the problem with the install via partition. You need to set it up as follows.
A fat32 partition, call it "osx" or something to identify it and make it the size you want your OSX partition to be.
Make a fat32 logical partition any size you want (you will delete it later) and call it "install"
Use a program like paragon partition manager (thats the one I used) to change the install partition ID to "AF." Its not an option on the list, but just change it to AF manually.
Then, use the program from here or here (both are great resources to read if you are stuck) and start it. Leave the iso on your desktop or something. Choose the install partition in the chinese program.
One you click "start," if you did it properly, it will take a few minutes to do its thing. The log should report all success except for changing it to AF. That was the only error I encountered however it still worked.
Then reboot, choose OSX, press any key, go down to the partition containing ideneb.
From there, you should get the installation screen, but its probably cut off. I pretty much guessed where i was clicking but used the screenshots in the wiki of this site as a guide. Also, as a recommendation, plug in an external mouse before booting the computer into the installer. the touchpad didn't work well and was being weird during installation.
The install is almost done. I'll post some picks later. Please feel free to ask questions or elaborate on anything.
p.s. I followed the ideneb wiki pretty much entirely for the installation except the part where it says "# To be sure you can select the drive and select "Partition". Press Options and you should see that the drive is partitioned as MBR$" in disk utility. I disregarded that and its probably not important anyway.
Edit1: It got stuck for a minute or so when it was nearly complete, but just leave it and it fill finish. Its now rebooting. (crossing fingers)
Edit2: Now its at the apple screen. The wheel was turning for about a minute, now it stopeed. I dont't know if its frozen or working. The HDD lite is working though
Edit3: Haha, just as i hit, save changes, it started working. now im at the welcome screen
Edit4: All is well. I had to do alot of guess clicking for setup, but its done now. I just installed the kexts and waiting for the reboot
Edit5: kext problems. not good. had to manually remove the integratedframebuffer and gma950 ones and hopfully it will boot correctly. I get a blue screen when booting up after the apple right now.